Cabinet hanger SAH 130- For press-fitting - For slat and hook suspension - Secured against lateral slipping in the case of hook suspension - Load capacity 35 kg / piece in accordance with EN 15939 in test frame A (one pair of SAH per cabinet - Attachments without their own suspension, e.g. end shelves, are not permitted. e.g. end shelf, are not permitted) - 3-dimensional alignment: Height ± 7 mm / depth max. 15 mm / sideways for hook suspension ± 3 mm / sideways for rail suspension ± 7 mm - Back panel offset (to front edge of back panel) min. 16 mm - Lifting height 7.5 mm - Can be used with suspension rail type A, type B and type L - Galvanised steel / white plasticInstructions for the load-bearing capacity of cupboard hangers and accessories- The following principles must be observed with regard to the load-bearing capacity of cupboard hangers and accessories:- Both the furniture design and the material and manufacturing quality of the furniture are beyond our control.- We also have no influence on the quality of the wall materials: - The suspension hooks we offer in conjunction with dowels are intended for use in solid bricks, sand-lime bricks, concrete or clinker bricks. A hole with a diameter of 8 mm must be drilled into the solid brick material, into which the plastic dowel is driven flush. The minimum hook screw-in depth corresponds to the hook length minus 10 mm.- For fastening to other wall materials, the commercially available special fastening elements must be used.- Dowels and screws must be matched to each other. Dowel screws must not be replaced by normal chipboard screws.- Fastening of hanging rails:- with 2 special screws Ø 5.5 x 50 mm in the area of each cupboard hanger- from a cupboard width of 900 mm, an additional special screw Ø 5.5 x 50 mm must be placed in the centre behind each cupboard (type A, type B and type H).- It is the responsibility of the furniture manufacturer/dealer to ensure that the furniture placed on the market complies with the requirements of EN 14749.