Hello, I bought this device at Digitec as a replacement for my Panasonic BluRay player.
I use it for a beamer (with a 10 metre HDMI cable in between).
Now it doesn't even transmit the picture after switching on the Sony player.
Is the signal from the new Sony too weak?

Question

Answer

Hello

Just to be sure - you go from the UBP-X700 directly to a beamer? Or is there a receiver in between? 
You don't see a start screen either? 10m should be easily doable with a reasonably good cable. But whether 4K material will then also go through could be close. However, you should be able to get to the start screen of the player. Try plugging in a slightly shorter cable (just for testing purposes). If this works, it is possible that the 10m cable has a defect. So please also connect the 10m cable to another source. 

I personally use a 15m HDMI (optical) slimrun AV cable HDR for HDMI capable devices, 4 K @ 60Hz, yuv4: 4: 4, silver/black. Unfortunately from another shop. 
If you can't find the error, please write in more detail about the set-up and the tested steps...

Best wishes and good luck,
highfish

Your data. Your choice.

Search

Question about Sony Ubp-X700

Hello, I bought this device at Digitec as a replacement for my Panasonic BluRay player. I use it for a beamer (with a 10 metre HDMI cable in between). Now it doesn't even transmit the picture after switching on the Sony player. Is the signal from the new Sony too weak?