1 non-potential-free switch 16A/250V AC, 230V LED lamps up to 200W, incandescent lamps 2300W. Standby loss only 0.5 watts. Modular device for mounting on DIN-EN 60715 TH35 mounting rail. 1 unit width = 18mm, depth 58mm. Contact switching at zero crossing to protect the contacts and lamps. State-of-the-art hybrid technology combines the advantages of wear-free electronic control with the high performance of special relays. Control voltage 230V and additionally galvanically isolated universal control voltage 8..230V UC. Supply and switching voltage 230V. Very low switching noise. Times adjustable between 0.1 seconds and 40 hours. Functions: RV = fall delay, AV = response delay, TI = pulse generator starting with pulse, TP = pulse generator starting with pause, IA = pulse-controlled response delay, EW = turn-on wipe, AW = turn-off wipe, ARV = response and fall delay, ON = continuous ON, OFF = continuous OFF. The LED under the upper rotary switch indicates the contact position during the timing process. It blinks as long as the working contact is open and lights continuously as long as it is closed. The time base T is set with the middle detent rotary switch T. Base values available are 0.1 seconds, 0.5 seconds, 2 seconds, 5 seconds, 1 minute, 2 minutes, 5 minutes, 1 hour, 2 hours, and 4 hours. The total time results from the time base multiplied by the multiplier. The multiplier xT is set with the upper detent rotary switch xT and ranges from 1 to 10. Thus, times between 0.1 seconds (time base 0.1 seconds and multiplier 1) and 40 hours (time base 4 hours and multiplier 10) can be set. The maximum load can be used from a delay or pulse time of 5 minutes. For shorter times, the maximum load is reduced as follows: Up to 2 seconds to 15%, up to 2 minutes to 30%, up to 5 minutes to 60%.