EUR84,90 was EUR106,81
Sennheiser BT T100
Channels
Question about Sennheiser BT T100
BT T100 connected via jack to amplifier phone out. Goal: Listen to sound via Bose Bluetooth headphones. After approx. 30 seconds, only chirping. Then have to "restart" Sennheiser with Input Selection Switch or Power Knob. Not usable at the moment. Ideas? I have no optical output on my amplifier. Same problem with the Phones Out of my Maschine 3 from Native Instruments. Connected to the mains via USB.
Hello Kevin
Since you have connected the BT T100 correctly, I would assume that the device is defective. For me, the transmitter works with a wide variety of devices.
What you should try is to change the power supply.
In general, when you try something, you should only make one change and try again, then make the next change. I'm sure I'm not telling you anything new.
If all attempts fail, replace the transmitter.
Greetings
Stephan
Since you have connected the BT T100 correctly, I would assume that the device is defective. For me, the transmitter works with a wide variety of devices.
What you should try is to change the power supply.
In general, when you try something, you should only make one change and try again, then make the next change. I'm sure I'm not telling you anything new.
If all attempts fail, replace the transmitter.
Greetings
Stephan