The SPAX typical drive T-STAR plus is a so-called internal hexagon. This shape increases the contact area of our T-STAR plus, allowing the T-STAR plus bits to fit perfectly into the screw head. The optimal power transmission from the screwdriver to the screw provided by T-STAR plus enables quick work, significantly more efficiently than with any other drives. The countersunk head (or flat countersunk head) carves a recess into the wood with its polygonal underside ("pockets") and can therefore be sunk without additional countersinking of the screw hole. The countersunk head sits flush with the surface. The screws with partial thread are excellent for fastening thin components like wood-based panels, boards, or floorboards to thicker components like beams or joists. The short thread screws into the thick component, while the unthreaded shaft remains in the attachment. This creates maximum clamping pressure between the two. The unthreaded part should be at least as thick as the attachment component. The term 4CUT refers to the square shape of the screw tip. These edges displace the wood fibers during insertion and create space for the screw's core diameter. The spreading pressure exerted by the core in the wood is thus reduced, preventing the wood from splitting near the edges. The required torque of the cordless screwdriver is also reduced, as the core of the screw does not have to "squeeze" into the wood. The abbreviation A2 in our stainless steel screws comes from the alloy of the steel. Screws made of stainless steel A2 offer high protection against corrosion and medium strength. Their resistance to seawater and acids is low. Therefore, they are used in outdoor applications in areas far from the coast.