Best Eltako products in the Weather station accessories category
On this page you'll find a ranking of the best Eltako products in this category. To give you a quick overview, we've already ranked the most important information about the products for you.
1. Eltako Rain sensor RS
The rain sensor RS reports rain to the downstream sensor relay LRW12D. A standard telephone cable J-Y(ST)Y 2x2x0.8 or equivalent is sufficient as the connection line. The permissible cable length is 100 m. It features a compact plastic housing with dimensions of 118x96x77 mm, protection class IP44, and an operating temperature range of -30 °C to +50 °C. A power supply SNT61-230V/24V DC or SNT12-230V/24V DC is required for the power supply, including heating of the rain sensor (1.2 W). An LED lights up green when power is supplied and yellow when it detects rain.
2. Eltako Wind sensor WS. Measurement of ambient conditions: Wind speed, transmission technology: Wired
Eltako Wind Sensor WS #20000082
Manufacturer: Eltako
Designation: Wind Sensor
Type: WS #20000082
Design: Wind Sensor
The wind sensor generates a pulse signal that depends on the speed of the wind turbine. This signal is evaluated in a downstream sensor relay LRW12D-UC. It features a robust plastic housing with dimensions of 125 x 117 mm and a protection rating of IP54. The temperature range is between -15 °C and +60 °C. It includes a plastic mounting bracket KM1 and is supplied with a 5-meter long connection cable.
EAN: 4010312901281.
Weather station accessories
EUR105,93
Eltako Wind sensor WS. Measurement of ambient conditions: Wind speed, transmission technology: Wired
3. Eltako Transmitting unit radio weather data transmitting module
Radio weather data transmission module for the seven weather data points of the multisensor MS. With an internal antenna. Standby power loss is only 0.3 watts. Designed for installation. Dimensions: 45 mm long, 45 mm wide, 18 mm deep. Supply voltage is 24 V DC from the 33 mm deep power supply SNT61-230V/24V DC-0.25A, which is also 45 mm long and 45 mm wide. This power supply simultaneously powers the multisensor MS, including the heating of the rain sensor. If necessary, a deep flush-mounted box should be installed for both devices together. This weather data transmission module receives the seven currently recorded weather data points—brightness (from three directions), twilight, wind, rain, and outside temperature—via cable J-Y (ST) Y 2x2x0.8 from the multisensor MS mounted outside the building, once per second, and transmits them as radio telegrams to the Eltako building radio system with the following priority. The evaluation is done with the building radio visualization and control software GFVS, the radio multifunction sensor relay FMSR14, the actuators FSB14 and FSB71, as well as the radio weather data display FWA65D. Upon applying the supply voltage, a learning telegram is sent immediately, followed by two status telegrams with all current values after about 60 seconds. Thereafter, at least every 10 minutes, but also: brightness values for West, South, and East from 0 to 99 kLux with a change of at least 10%. Twilight values from 0 to 999 Lux with a change of at least 10%. Wind speeds from 0 to 70 m/s. From 4 m/s to 16 m/s, the current values are sent immediately three times at one-second intervals, and then increasing values are sent within 20 seconds. Decreasing wind speeds are sent in stages with a 20-second delay. Rain is reported immediately three times at the start, and within 20 seconds after it ends. Temperature values from -40.0 °C to +80.0 °C are sent every 10 minutes, along with all other values in a status telegram.
4. Eltako ELTA weather data multisensor
The weather data multisensor WMS transmits the currently recorded weather data once per second: brightness from three directions 0-99,000 Lux, wind speed 0-35 m/s, rain, and temperature -40-80 °C to the connected MSR12-UC, FWG14MS, or FWS61-24V DC. A standard telephone cable J-YSTY 2x2x0.8 or equivalent is sufficient as the connection line. The permissible cable length is 100 m. It features a compact plastic housing with dimensions L x W x H of 118 x 96 x 77 mm, protection class IP44, and an operating temperature range of -30 °C to 50 °C. A power supply unit WNT15-24VDC24W or WNT61-24VDC10W is required for powering the device, including heating for the rain sensor. To evaluate a WMS multiple times, up to 64 evaluation units MSR12-UC, FWG14MS, or FWS61-24V DC can be connected to the weather data multisensor.
