Thin-bed set with touch thermostat, flexible sensor protection pipe DN10 with red cap, plastic nails, installation instructions. The self-adhesive thin-bed heating mat with a connection cable is ready to install and has been specially developed for installation in levelling compound or flexible adhesive directly underneath the floor covering. Thanks to its low installation height of just 3.2 mm, it is ideal for renovating and modernising bathrooms, showers, kitchens, etc. This floor temperature control system is particularly suitable for retrofitting in angled and/or large rooms, as there is no need to run back the second connection. The heating cable with additional protective braiding for use of the residual current circuit breaker is attached to a plastic net. The length of the connecting cables is 4.0 m. PTC thermistor: 1 x 4m, 1.0 mm², voltage: 230 V, nominal limit temperature: 120 °C, specific heat output: 150 W/m², linear load: 11 W, insulation: PVDF / FEP, resistance tolerance: +10% / -5%, minimum installation temperature: 5 °C, smallest bending radius: 6 x dA, calculation width: 50 cm, delivery width: 48 cm, mat height: 3.2 mm, protection rating: IPX7, approval: EN 60335-2-96, area: 6.0 m², 0.5 x 12.0 m.