Best selling RC aircrafts from Amewi
On this page you'll find a ranking of the best Amewi products in this category. To give you a quick overview, we've already ranked the most important information about the products for you.
1. Amewi Maule M7
Amewi motor plane Maule M7 3D/6G Gyro 4 channel, 510 mm, Aircraft type: Motor plane, Drive type: Electric brushless, Model design: RTF (Ready to Fly), Material: EPP, Required for completion: Batteries for transmitter, Detail colour: Red
2. Amewi XFly Delta Flyer red
The XFly Eagle Twin 40mm EDF Jet features a special flying wing configuration, a newly developed 40mm EDF propulsion system at both wingtips, and a large battery compartment in the center of the fuselage. Powered by a 4S LiPo battery, the factory-installed 40mm EDF twin nozzles give the aircraft a power-to-weight ratio of over 1:1.5, allowing for effortless hand launches. The wear-resistant plastic parts under the belly and wingtips enable the aircraft to land on rough surfaces. With a streamlined, aerodynamic profile, a special EDF configuration, and a setup supported by an optional custom gyro, the Eagle is capable of achieving differential speeds, performing rolls, flat spins, inverted flat spins, and other challenging maneuvers, with a top speed of over 110 MPH. It comes fully assembled and is ready to fly immediately. Two striking color schemes are available, so you won't have to worry about losing sight of the aircraft in the sky. If you're looking for a hand-launch racing plane, the XFly Eagle is the perfect choice for you.
3. Amewi Warbird AMXflight P51 560 mm 4-channel, Gyro, RTF
Small P51 Mustang WWII fighter aircraft with 3D/6G gyro. Brushless motor for strong flight performance and durability of the drive. Switchable LED lighting allows for flights at dusk. Receiver board with 3V and 5V connections for optional S. BUS or DSM satellite receivers. Beginner-friendly thanks to the 3D/6G gyro. 4-channel control: ailerons, elevator, rudder, motor control. Includes 2S 600 mAh LiPo battery for flight times of up to 7 minutes. A brushless motor is a type of electric motor without brushes, which offers higher efficiency, less wear, and lower weight compared to brushed motors. Difficulty level: beginner. No special knowledge in model building is required for this product. The necessary materials for completion and commissioning are usually fully included in the delivery. RTF - Ready to Fly. RTF models are ready to use straight out of the box. You receive a complete package with a pre-assembled model and a compatible transmitter – just unpack and get started, that's the motto of "Ready to Fly" models. Due to their ease of use, this type is ideal for entering the world of model sports.
4. Amewi J-11
Replica of the Shenyang J-11 or Jian-11 - a single-seat, twin-engine fighter from China. This was originally a licensed variant of the Russian Su-27SK, but the newer version, the J-11B, has been completely redeveloped. The model impresses with its flight performance and fully automatic attitude stabilization (gyro), which gives very pleasant flight characteristics and makes it fully suitable for beginners. Since the J-11 replica is delivered RTF (Ready to Fly), no more screwing, drilling or gluing is required before takeoff. The built-in gyro immediately takes over flight stabilization in the air and the pilot can focus on actually controlling the model. As soon as no more control input is made, the model goes back into horizontal straight flight. By pressing a button on the transmitter, the gyro can be switched off, e.g. for loops (stabilized max. 15 - 20°, climb flight possible). If, however, the flight attitude should become uncertain, the gyro switch serves as a lifeline. Thus, immediately after pressing the button, the model is automatically brought back into a stable flight attitude. The robust, impact-resistant EPP material also allows for harder crashes and landings. It is easy to repair or glue.
5. Amewi AMXFlight Beech D17s biplane 3D/6G
AMXFlight Beech D17s biplane 3D/6G RTF yellow This semi-scale model of the famous Staggerwing, which was first built in the 1930s, impresses with its outstanding appearance and compact, boot-friendly dimensions. The biplane impresses with its good-natured flight characteristics and numerous scale details, such as switchable position lights, a dummy radial engine, a scale propeller, detailed undercarriage, pilot figures and a 3D/6G gyro, which also makes it easy for beginners to get started. The activatable gyro support largely compensates for wind influences, for example, so that the aircraft flies like a large model. In 6G mode, the model is fully stabilised and the rate of climb and pitch is limited, which prevents stalling. As soon as the control stick is released, the electronics automatically return the aircraft to a straight and stable flight attitude. When the switch is set to 3D mode, the AMXFlight Beech unleashes its full potential and, thanks to the powerful brushless drive and 2S LiPo batteries, transforms into a fully-fledged aerobatic biplane with an impressive range of speeds. In this mode too, the built-in gyro supports the pilot in all positions and ensures a safe and familiar flying experience. In addition, the built-in receiver is equipped with 3V and 5V outputs for S-Bus and DSM receivers so that existing remote control systems can also be used. 3D/6G gyro already installed: Fully suitable for beginners, including additional connections on the receiver for S-Bus and DSM receiver.
- Remote control in Mode 2
- Wingspan of 550 mm
- Suitable for beginners and advanced pilots
- 6-axis gyro can be switched on and off
- Powerful brushless motor
- Flight time of approx. 9 minutes per battery charge.
6. Amewi Motor aircraft GlaStar 1233 mm STOL Trainer PNP
AMXPlanes GlaStar Trainer model with bush wheels. Oversized air tires allow for takeoffs and landings on uneven runways. Easy to transport thanks to the detachable wing and tailplane. Powerful 3136 1000 kV brushless motor with 20 A controller. RC functions: rudder, elevator, ailerons, motor control. Made from durable EPO foam. Recommended battery: 3S 1300 - 2200 mAh LiPo. The AMXPlanes GlaStar is a STOL trainer model that can take off and land on almost any surface due to its oversized tires. The air-filled tires act as a kind of shock absorber, enabling smooth takeoffs and landings on uneven and rough terrain. STOL (Short Take-Off and Landing) refers to extreme short takeoff and landing capabilities. The model features a large battery cover that locks magnetically to make battery changes as easy as possible. It is designed for 3S (11.1 V) LiPo batteries with a capacity of 1300-2200 mAh. With 1300-1500 mAh, the model's agility is higher, and with 1800-2200 mAh, the flight time increases significantly. The design and flight characteristics appeal to both beginners and advanced pilots alike. PNP - Plug and Play. These models are nearly flight-ready configured. The motor, controller, and servos are already mounted and wired. Unlike RTF models, you will need additional accessories before the model is ready for use. Brushless motor. A brushless motor is an electric motor without brushes, which offers higher efficiency, less wear, and lower weight compared to brushed motors. Skill level: beginner. No special prior knowledge in modeling is required for this product. The necessary materials for completion and commissioning are usually included in the delivery.
7. Amewi Kita1 flying wing
This concept offers enormous flight times thanks to a battery capacity of up to 10,000 mAh (flight times of up to 70 minutes). A 600 TVL FPV camera and a 200 mW video transmitter are already pre-installed and ready for flight. Simply pair this fantastic model with a video goggles or monitor and experience your flight from the pilot's perspective. The system also includes a mount for a GoPro or similar cameras, allowing for extended video flights without any hassle. Thanks to the long flight time, large areas (such as coastlines, mountains, or lakes) can be filmed uniquely. The gentle flying characteristics of this model invite beginners with little flying experience to enjoy this great model. Only a transmitter with delta mixer, a receiver, and a flight battery from 2200 mAh 3S 11.1 V to 10,000 mAh 3S 11.1 V are needed, and then you're ready to go. This model can be easily converted into a true racer with just a few adjustments. Simply remove the center section, reattach the wings, connect the motor with the mount, and you have a race wing with a high speed range.
8. Amewi F-22 Raptor
The F-22 Raptor is a fifth-generation air superiority fighter exclusively used by the US Air Force as the successor to the F-15A-D Eagle. Notable features include its stealth capabilities, modern avionics, and the ability to fly supersonically without afterburners. Its maximum speed is 2,414 km/h, and it has a range of approximately 3,000 km.
The AMX Flight F-22 is a scale replica in PNP (Plug and Play) version. The model is largely pre-assembled; assembly is limited to attaching the wings, linkages, and tail. All servos (2x 9g), the 50 mm 11-blade impeller including a 4900KV brushless motor, and the 30A Hobbywing ESC are already installed.
The jet is designed to accommodate 3S LiPos between 850 and 1000 mAh, allowing the F-22 to achieve impressive flight performance. The speed ranges from fast to slow, making it suitable for less experienced pilots as well. Maneuverability and roll rate are also impressive, offering a wide range from very agile to docile. The takeoff behavior is completely uncritical, allowing the model to be easily hand-launched. The jet shows no tendencies to the typical sinking of an impeller model. Due to its small size, the model is the perfect trunk flyer for quick outings and provides a lot of enjoyment even in a group with multiple models. A special feature of our F-22 is that the elevator and ailerons are connected via a servo to the control horns, significantly enhancing the model's agility.
9. Amewi F16B
F16B Jet model including Gyro. A small, particularly beginner-friendly replica of the F-16 jets. The model is delivered as a complete package with transmitter, battery, and charger; only the batteries for the transmitter are still needed (4 x 1.5 V AA). After charging the battery and assembling the vertical stabilizer, which is screwed onto the fuselage, the F16 replica is ready to fly. Once turned on and the flight stabilization (Gyro) is initialized, the model can be launched from the hand with a gentle push. The operation is incredibly easy thanks to a special beginner design: throttle controls the altitude (more throttle = climbing, less throttle = descending) and the two motors mounted on the wings steer the model (right/left). The latter also automatically control the stability, allowing beginner pilots to simply enjoy their first flights. The model is made of impact-resistant, easily repairable EPP, making it capable of withstanding harder landings without any issues.
10. Amewi AMXFlight L-39 Albatros EPO PNP
The Aero L-39 Albatros is a two-seat, single-engine training aircraft developed in Czechoslovakia as the successor to the L-29 Delfín, and it is still used by the air forces of several nations today. The Amewi version is a small, agile jet in PNP (Plug and Play) configuration. The aircraft comes mostly pre-assembled, with assembly limited to attaching the wings, linkages, and tail section. All servos (3x 8 grams), the 50 mm impeller including a 4300KV brushless motor, and a 20A Hobbywing ESC are already installed. The jet is designed to accommodate 3S Li-Po batteries ranging from 850 to 1000 mAh, giving the L-39 impressive flight performance. The speed ranges from fast to slow, making it suitable for less experienced pilots as well. Its agility and roll rate are also impressive, offering a wide range from very nimble to docile. The takeoff behavior is completely non-critical, allowing the model to be easily hand-launched. The jet shows no tendencies towards the typical nose-down behavior of impeller models. Due to its small size, the model is the perfect trunk-sized flyer for quick outings and provides a lot of fun even in a fleet with multiple models.
