EUR117,89
Ubiquiti UISP-S
9 ports
Question about Ubiquiti UISP-S
I have a Ubiquiti controller, then the UISP switch and then three U6+ APs. But I can't get any power to the APs, even though I have set it up in the software. It works fine with an injector. Question: Is the switch even equipped with POE????
This switch can only use PoE 24V DC passive (proportional from Ubiquiti), but you need 802.3af (IEEE standard) with 15W 44V DC.
Furthermore, this is not a Ubiquiti UniFi device and cannot be integrated into the UniFi Controller, but is managed via the UISP.
Furthermore, this is not a Ubiquiti UniFi device and cannot be integrated into the UniFi Controller, but is managed via the UISP.
Hello... Yes, it has PoE... but only 27V passive.
But the U6+ access points need 44-57V.
So unfortunately there is not enough power for it.
If you want to keep the router, the
UniFi AP AC-LITE would be an option...
If you want to keep the AP's...
Ubiquiti USW-LITE-8-POE
But the U6+ access points need 44-57V.
So unfortunately there is not enough power for it.
If you want to keep the router, the
UniFi AP AC-LITE would be an option...
If you want to keep the AP's...
Ubiquiti USW-LITE-8-POE
Do NOT use POE on this Switch with ANYTHING, unless you're sure it supports PASSIVE POE, you risk of frying the device's port.